Rohde & Schwarz R&S ZNA Series - Page 360

GUI reference
R&S
®
ZNA
360User Manual 1178.6462.02 ─ 29
The notation for wave quantities follows the usual scheme of the vector network ana-
lyzer:
●
The a-waves are the outgoing/transmitted waves at the analyzer's test ports.
●
The b-waves are the incoming/measured waves.
●
The source port for the stimulus signal must be specified in addition.
●
The port number range covers all test ports of the analyzer.
Define
The controls in this section of the dialog allow you to set the "Wave" type, the "Receiv-
ing Port" and the "Source Port".
The latter is only available, if no external source is used (see "Use Generator as
Source" on page 360).
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "A1" ...
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "A1" ...
Use Generator as Source
If checked, the "Generator" combo lists the configured external generators and the
"Source Port" group of the Define section is disabled
Meas softtool