Rohde & Schwarz R&S ZNA Series - Page 430

GUI reference
R&S
®
ZNA
430User Manual 1178.6462.02 ─ 29
Alternatives to Zooming
There are several alternatives to graphical/numerical zooming. Refer to the following
sections:
●
Chapter 3.3.7, "Scaling diagrams", on page 66
●
Chapter 5.4.1, "Scale Values tab", on page 425
●
Chapter 3.3.3, "Touchscreen gestures", on page 54 (zoom stimulus via spreading
and pinching)
●
Chapter 5.8.1, "Stimulus tab", on page 522
Mode Graphical Zoom/Mode Stimulus Zoom
Switches between graphical and stimulus zoom mode.
Use the zoom selection button to initiate the selection of a (paraxial) rectangular zoom
area. Its label changes according to the selected zoom mode.
Remote command:
n.a.
Zoom Select/Stim. Zoom Select
Prepares the analyzer GUI for the selection of a (paraxial) rectangular zoom area.
The effect of the subsequent selection depends on the current zoom mode (as indica-
ted on the button label):
●
In "Mode Graphical Zoom" (button label "Zoom Select"), the selected rectangle is
magnified without modifying any sweep parameters.
●
In "Mode Stimulus Zoom" (button label "Stim. Zoom Select") the selected rectangle
is magnified as well, but at the same time the sweep range of the active channel is
narrowed to the rectangle's horizontal range.
Scale softtool