ST ST10F276E - Page 124

Interrupt and trap functions UM0404
124/564 DocID13284 Rev 2
Bit Function
FL.0
Interrupt Flag 0: XPWM Channel 3...0
‘0’: No interrupt request.
‘1’: Interrupt request pending.
FL.1
Interrupt Flag 1: I2C Transmit
‘0’: No interrupt request.
‘1’: Interrupt request pending.
FL.2
Interrupt Flag 2: I2C Receive
‘0’: No interrupt request.
‘1’: Interrupt request pending.
FL.3
Interrupt Flag 0: XSSC Transmit
‘0’: No interrupt request.
‘1’: Interrupt request pending.
FL.4
Interrupt Flag 4: XSSC Receive
‘0’: No interrupt request.
‘1’: Interrupt request pending.
FL.5
Interrupt Flag 5: XASC Transmit Buffer
‘0’: No interrupt request.
‘1’: Interrupt request pending.
FL.6
Interrupt Flag 6: XASC Transmit
‘0’: No interrupt request.
‘1’: Interrupt request pending.
FL.7
Interrupt Flag 7: XASC Receive
‘0’: No interrupt request.
‘1’: Interrupt request pending.
IE.0
Interrupt Enable 0: XPWM Channel 3...0
‘0’: Interrupt request disabled.
‘1’: Interrupt request enabled.
IE.1
Interrupt Enable 1: I2C Transmit
‘0’: Interrupt request disabled.
‘1’: Interrupt request enabled.
IE.2
Interrupt Enable 2: I2C Receive
‘0’: Interrupt request disabled.
‘1’: Interrupt request enabled.
IE.3
Interrupt Enable 3: XSSC Transmit
‘0’: Interrupt request disabled.
‘1’: Interrupt request enabled.
IE.4
Interrupt Enable 4: XSSC Receive
‘0’: Interrupt request disabled.
‘1’: Interrupt request enabled.
IE.5
Interrupt Enable 5: XASC Transmit Buffer
‘0’: Interrupt request disabled.
‘1’: Interrupt request enabled.