Chrysler 2000 LHS - Page 1024

SPECIFICATIONS
3.2L ENGINE
DESCRIPTION SPECIFICATION
Type 60° SOHC V-6 24-Valve
Displacement 3.2 Liters
(195 Cubic Inches)
Bore and Stroke 92.0 x 81.0 mm
(3.622 x 3.189 in.)
Compression Ratio 9.5:1
Lead Cylinder #1 Right Bank
Firing Order 1-2-3-4-5-6
Cylinder Block
Cylinder Bore Diameter 92.0 mm 60.0076
(3.622 in. 60.0003 in.)
Out-of-Round (Max.) 0.076 mm
(0.003 in.)
DESCRIPTION SPECIFICATION
Taper (Max.) 0.051 mm
(0.002 in.)
Pistons
Type Material Aluminum (Full Floating
Pins)
Clearance at Size
Location
–0.007 to +0.047 mm
(–0.0003 to +0.0018 in.)
Piston Weight
—A Size 409–414 grams
(14.4271–14.6035 oz.)
—B Size 404–409 grams
(14.2507–14.427 oz.)
Piston Ring Groove
Diameter
—No. 1 83.69–83.89 mm
(3.2949–3.3028 in.)
—No. 2 81.12–81.32 mm
(3.1937–3.2016 in.)
—No. 3 82.3–82.5 mm
(3.2402–3.2481 in.)
Piston Pins
Type Full Floating
Clearance in Piston 0.005–0.015 mm
(0.0002–0.0006 in.)
Clearance in Rod 0.007–0.018 mm
(0.0003–0.007 in.)
Diameter 23.997–24.000 mm
(0.9448–0.9449 in.)
Piston Rings
Ring Gap—Top
Compression Ring
0.20–0.36 mm
(0.008–0.014 in.)
Ring Gap—2nd
Compression Ring
0.22–0.49 mm
(0.0087–0.0193 in.)
Ring Gap—Oil Control
(Steel Rails)
0.25–0.76 mm
(0.010–0.030 in.)
Ring Side Clearance
Top and Second
Compression Ring
0.040–0.080 mm
(0.0016–0.0031 in.)
Oil Ring (Steel Rails) 0.038–0.184 mm
(0.0015–0.0073 in.)
Fig. 147 Timing Belt Inspection
1 – PEELING
2 – TOOTH MISSING AND CANVAS FIBER EXPOSED
3 – RUBBER EXPOSED
4 – CRACKS
5 – PEELING
6 – ROUNDED EDGE
7 – ABNORMAL WEAR (FLUFFY STRAND)
LH 3.2/3.5L ENGINE 9 - 143
CLEANING AND INSPECTION (Continued)