INSTALLATION
(1) Position the assembled seat back and feed wire
harness down into lower seat cushion (Fig. 11). Be
certain harness is routed along the leading edge of
seat frame.
(2) Install inboard and outboard pivot bolts.
Tighten bolt to 30 N·m (23 ft. lbs.) torque.
CAUTION: Do not reuse recliner assembly attach-
ing bolts. Due to the nylon coating on these bolts
they are not reusable.
(3) Install bolts attaching recliner to seat back
frame (Fig. 12). Tighten bolts to 8 N·m (71 in. lbs.)
torque.
Fig. 9 Seat Back Wire Connectors
1 – SEAT TRACK RETAINING BOLTS
2 – SEAT AIRBAG WIRE HARNESS
3 – SEAT AIRBAG WIRE HARNESS CONNECTOR
4 – CUSHION PAN
Fig. 10 Recliner Attaching Bolts
1 – RECLINER BOLT
Fig. 11 Seat Back Wire Harness
1 – FRONT SEAT BACK
2 – SEAT AIRBAG WIRE HARNESS
3 – FRONT SEAT CUSHION
Fig. 12 Recliner Attaching Bolts
1 – RECLINER BOLT
23 - 6 BODY LH
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
