July 2013 9.5 Data Transfer NC > PLC, PLC > NC 1719
Traverse range
230 2 1 to 9
(X, Y, Z, A, B, C,
U, V, W)
Negative software limit switches
31 to 9
(X, Y, Z, A, B, C,
U, V, W)
Positive software limit switches
4 Number of axes
whose software
limit switches
are to be
overwritten
Number of the first of several
consecutive Q parameters
1st Q: Neg. limit switch in 1st axis
2nd Q: Pos. limit switch in 1st axis
3rd Q: Neg. limit switch in 2nd axis
etc.
5 – Limit-switch monitoring
(1 = off, 0 = on)
Swivel axes
290 1 – Description of tilting-axis geometry
5 – 0: Temperature compensation not
active in the kinematics table
1: Temperature compensation active
in the kinematics table
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum
To Next Page
Loading...
