1718 HEIDENHAIN Technical Manual iTNC 530 HSCI
27 Tool no. Tool type for pocket table
28 Tool no. Maximum rpm NMAX
29 Tool no. PLC value P1
30 Tool no. PLC value P2
31 Tool no. PLC value P3
32 Tool no. Point angle for DRILL and CSINK
T-ANGLE
33 Tool no. Thread pitch for TAP
PITCH
Edit multiple-task tool
53 See FN 17-ID50 Tool no. Completely edit the data of a
multiple-task tool for all indexes.
Behaves like FN17-ID50, only that
here the same value is written to all
indexes.
7 – Completely disable all indexes of the
current multiple-task tool:
FN 17: SYSWRITE ID 53 NR7 = 1.0
Edit multiple-task tool
59 10 – Recalculation of the spindle speed by
means of the present tool radius from
TOOL.T if a cutting velocity is
programmed in the TOOL CALL
block. The spindle speed is entered in
the system datum that can be read
with FN18: SYSREAD ID60 NR3.
Coordinate transformations
210 1 – Basic rotation (manual)
3 – Active mirror axis
Bits 0 to 2 and 6 to 8:
Axes X, Y, Z and U, V, W
6 – Tilt working plane in Program Run
mode
(0 = inactive, –1 = active)
7 – Tilt working plane in Manual mode (0
= inactive, –1 = active)
Exchange tool axis
212 – – 0: Tool axis Z
1: Tool axis X
2: Tool axis Y
3: Tool axis from
TOOL CALL
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum
To Next Page
Loading...
