HEIDENHAIN iTNC 530 HSCI - Page 1722

1722 HEIDENHAIN Technical Manual iTNC 530 HSCI
0 1.0 Time in seconds after which the
teach-in cuts of the AFC are
automatically ended.
0: Function not active
0 3.0 Definition of reference power in [%]
of the rated power output of the
spindle
0 4.0 Monitoring of tool wear:
Definition of a monitoring limit in [%]
of the reference power. PLC Marker
4510 is set if the monitoring value is
exceeded.
0 5.0 Spindle load monitoring (cut-based):
Definition of a monitoring limit in [%]
of the reference power An NC stop is
triggered if the monitoring value is
exceeded.
Spindle load monitoring independent of cutting
622 Filter constant:
1 to 60 ms
6.0 Spindle load monitoring (independent
of cutting):
Definition of monitoring limit in [%] of
the rated power output of the spindle.
An NC stop is triggered if the
monitoring value is exceeded.
Touch probe cycles
990 1 – Approach behavior:
0 = standard behavior
1 = effective radius, set-up clearance
is zero
2 – 0.0 = touch probe monitoring off,
M4057 not used
1.0 = touch probe monitoring on,
M4057 not used
2.0 = touch probe monitoring off,
M4057 used
3.0 = touch probe monitoring on,
M4057 used
3 – Place probe data of the manual
probing cycles into the tool table
6 – Touch probe cycle 3
0.0 = TS inputs at X112
1.0 = TT inputs at X112
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum