July 2013 9.5 Data Transfer NC > PLC, PLC > NC 1727
16 Tool no. TT: Wear tolerance for length LTOL
17 Tool no. TT: Wear tolerance for radius RTOL
18 Tool no. TT: Direction of rotation DIRECT
0 = Positive, –1 = Negative
19 Tool no. TT: Offset in plane R-OFFS
R = 99999.9999
20 Tool no. TT: Offset in length L-OFFS
21 Tool no. TT: Break tolerance in length
LBREAK
22 Tool no. TT: Breakage tolerance in radius
RBREAK
23 Tool no. PLC value
24 Tool no. Probe-center offset in reference axis
CAL-OF1
25 Tool no. Probe-center offset in minor axis
CAL-OF2
26 Tool no. Spindle angle for calibration
CAL-ANG
27 Tool no. Tool type for pocket table
28 Tool no. Maximum rpm NMAX
29 Tool no. PLC value P1
30 Tool no. PLC value P2
31 Tool no. PLC value P3
32 Tool no. Point angle for DRILL and CSINK
T-ANGLE
33 Tool no. Thread pitch for TAP
PITCH
Data from the pocket table
51 1 Pocket number Tool number
2 Pocket number 0 = no special tool
1 = special tool
3 Pocket number 0 = no fixed pocket
1 = fixed pocket
4 Pocket number 0 = pocket not locked
1 = pocket locked
5 Pocket number PLC status
6 Pocket number Tool type
7 to 11 Pocket number P1 to P5
12 Pocket number 0 = not a reserved pocket
1 = reserved pocket
13 Pocket number Pocket above is locked
14 Pocket number Pocket below is locked
15 Pocket number Pocket to the left is locked
16 Pocket number Pocket to the right is locked
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum
To Next Page
Loading...
