July 2013 9.5 Data Transfer NC > PLC, PLC > NC 1735
Touch probe cycles
990 1 – Approach behavior
0 = standard behavior
1 = effective radius, set-up clearance
is zero
2 10 0.0 = execution not in block scan 1.0
= execution in block scan
–1.0 = invalid index
16 0.0 = execution not in Automatic
operating mode
1.0 = execution in Automatic
operating mode
–1.0 = invalid index
4 – 0.0 = spindle or
1.0 = touch probe deflected
10 <no.> Tool number that belongs to the tool
name of Q parameter IDX <no.>
Coordinate transformation
3 No. of the 1st of
9 consecutive Q
parameters for
axes X, Y, Z, A,
B, C, U, V, W
Number of axes that are programmed
in the selected datum table
8 – Current spindle angle
Machine parameters
1000 MP number MP index Value of the machine parameter
(even with MP1054.x and MP7530.x,
if they don’t have a formula). The
entered values of non-active MPs are
also supplied.
410 3 or 4 ASCII value of the axis designation
from MP410.3 or MP410.4
1010 MP number MP index 0 = MP does not exist
1 = MP exists
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum
To Next Page
Loading...
