HEIDENHAIN iTNC 530 HSCI - Page 532

532 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP4131.0
MP4131.1
MP4131.2-5
Activation criterion for the fast PLC input for switching the
monitoring functions off (with HSCI, this is also possible via
MP4132.x)
Reserved
Activation criterion for fast PLC inputs
Input: 0: Activation at low level
1: Activation at high level
895,
863,
1753
MP4132.0-7 Axis-specific drive enable, switch-off of monitoring
functions
Input: 0 to 20000 [Number of the PLC input or symbolic
PLC operand]
–1: Function not active
863,
930
MP4210.0-47 Setting a number in the PLC (D768 to D956)
Input: –99 999.9999 to +99 999.9999
973,
1739
MP4220.0-4 Setting a number in the PLC (W960 to W968)
Input: 10 to 30 000
1739
MP4230.0-31 Setting a number in the PLC (Module 9032)
The number of indexes can be increased via an entry in
OEM.SYS.
Input: –99 999.9999 to +99 999.9999
1739
MP4231.0-31 Setting a number in the PLC (Module 9032)
Input: –99 999.9999 to +99 999.9999
1739
MP4310.0-9 General parameters in the PLC (W976 to W994, M4300 to
M4459)
Format: Number, $xxxx [Hex], %xxxxxxxxxxxxxxxx [Bin]
Input: 0 to 65535
1739
MP4400 Profibus configuration
Input: %xx
Bit 0 – Definition of option sequence
0: Sequence as in *.IOC file
1: Sequence as in MP4000.x
Bit 1—reserved
MP Function and input Software
version and
behavior
Page