538 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP6500 Tool measurement with TT 130
Format: %xxxxxxxxxxxxxxx
Input: Bit 7 – Reserved
Bit 8 – Probing routine
0: Probe contact is probed from several directions
1: Probe contact is probed from one direction
Bit 9 – Automatic measurement of the direction of the
probe contact basic rotation (bit 8 = 1)
0: Basic rotation is not measured
1: Basic rotation of the probe element is automatically
measured
Bit 10 – Probing routine (bit 8 = 1)
0: Pre-positioning to starting point in all three principal axes
1: Pre-positioning to starting point in the tool axis and in the
axis of the probing direction (MP6505) (bit 9 = 0)
Bit 11 – Tool checking and changing in the tool table
0: After Tool checking the tool table is changed
1: After Tool checking the tool table is not changed
Bit 12 – PLC datum shift
0: Do not include
1: Include
Bit 13 –
0: Tool is measured in the tilt position in which the tool
touch probe was also calibrated
1: Tool is measured in another tilt position
Bit 14 – Tool measurement with number of teeth = 0
0: Tool measurement with rotating spindle
1: Tool measurement with stationary spindle
PLC
RUN
MP6505 Probing direction for tool radius measurement for 3 traverse
ranges
Input: 0: Positive probing direction of the angle
reference axis (0° axis)
1: Positive probing direction in the +90° axis
2: Negative probing direction of the angle reference axis (0°
axis)
3: Negative probing direction in the +90° axis
PLC
RUN
CN123
1554
MP6505.0 Traverse range 1
MP6505.1 Traverse range 2
MP6505.2 Traverse range 3
MP6507 Calculation of the probing feed rate
Input: 0: Calculation of the probing feed rate with
constant tolerance
1: Calculation of the probing feed rate with variable
tolerance
2: Constant probing feed rate
PLC
RUN
CN123
1557
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
