HEIDENHAIN iTNC 530 HSCI - Page 540

540 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP6562 M function before and after tool measurement cycle (TT
cycle)
Input: –1: Function inactive
0 to 999: Number of the M function
349 490-06
PLC
RUN
CN123
1560
MP6562.0 M function before the cycle start
MP6562.1 M function after cycle end
MP6570 Max. permissible surface cutting speed at the tooth edge
Input: 1.0000 to 129.0000 [m/min]
PLC
RUN
CN123
1557
MP6572 Maximum permissible speed during tool measurement
Input: 1 to 1000 [min
–1
]
0: 1000 [min
–1
]
PLC
RUN
CN123
1557
MP6580.0-2 Coordinates of the TT 130 probe contact center with
respect to the machine datum (traverse range 1)
Input: –99 999.9999 to +99 999.9999 [mm]
PLC
RUN
CN123
1555
MP6581.0-2 Coordinates of the TT 130 probe contact center with
respect to the machine datum (traverse range 2)
Input: –99 999.9999 to +99 999.9999 [mm]
PLC
RUN
CN123
1555
MP6582.0-2 Coordinates of the TT 130 probe contact center with
respect to the machine datum (traverse range 3)
Input: –99 999.9999 to +99 999.9999 [mm]
PLC
RUN
CN123
1555
MP6585 Monitoring the position of the rotary and additional linear
axes during the tool measurement cycles
Format: %xxxxxx
Input: 0: Axis is not monitored
1: Axis is monitored
Bit 0 – A axis
Bit 1 – B axis
Bit 2 – C axis
Bit 3 – U axis
Bit 4 – V axis
Bit 5 – W axis
PLC
RUN
CN123
1558
MP Function and input Software
version and
behavior
Page