HEIDENHAIN iTNC 530 HSCI - Measuring, testing and inspection equipment

July 2013 4.4 List of machine parameters 559
MP7440 Output of M functions
Format: %xxxxxxx
Input: Bit 0 – Program stop with M06
0: Program stop with M06
1: No program stop with M06
Bit 1 – Modal cycle call M89
0: Normal code transfer of M89 at beginning of block
1: Modal cycle call M89 at end of block
Bit 2 – Program stop with M functions
0: Program stop until acknowledgment of the M function
1: No program stop. No waiting for acknowledgment.
Bit 3 – Switching of k
v
factors with M105/M106:
0: Function is not in effect
1: Function is effective
Bit 4 – Reduced feed rate in the tool axis with M103:
0: Function is not in effect
1: Function is effective
Bit 5 – Reserved
Bit 6 – Automatic activation of M134
0: M134 must be activated in the NC program
1: M134 is automatically activated when an NC program is
selected
Bit 7 – Internal spindle status of the geometry
0: With M00 the internal spindle status switches to M05
1: With M00 the internal spindle status does not switch to
M05
PLC
RUN
CN123
771,
834,
836,
1257,
1564,
954
MP7441 Error message during cycle call
Format: %xxx
Input: Bit 0 –
0: Error message Spindle ? is not suppressed
1: Error message Spindle ? is suppressed
Bit 1: Reserved, enter 0
Bit 2 –
0: Error message Enter depth as negative is suppressed
1: Error message Enter depth as negative is not
suppressed
PLC
RUN
CN123
1257
MP7442 Number of the M function for spindle orientation in the fixed
cycles
Input: 1 to 999: Number of the M function
0: No oriented spindle stop
–1: Oriented spindle stop by the NC
PLC
RUN
CN123
968
MP Function and input Software
version and
behavior
Page