HEIDENHAIN iTNC 530 HSCI - Page 596

596 HEIDENHAIN Technical Manual iTNC 530 HSCI
M 4522 Tool with pocket number programmed is
in effect with MP7480.0 = 3 or 4 and
TOOL CALL
NC NC 1613
M 4523 Tool without pocket number programmed
is in effect with MP7480.0 = 3 or 4 and
TOOL CALL
NC NC 1613
M 4524 Special tool called, TOOL CALL NC NC 1613,
1629
M 4525 TOOL CALL after expiration of tool life NC NC 1613
M 4526 -
4534
Axis 1 to axis 9 is the tool axis NC NC 622
M 4538 Geometry of the tool from W264 PLC NC 1246,
1611
M 4539 Tool number highlighted in the status
display
PLC PLC –
M 4540 Sequence of tool number or pocket
number transfer (M4520 = 1)
PLC PLC 1613,
1629
M 4541 Special tool in original pocket in spite of
variable pocket coding
PLC PLC 1593,
1613,
1629
M 4542 Do not update pocket number in the
pocket table
PLC PLC 1246,
1613
M 4543 Tool life 1 expired (TIME1 in the tool table) NC NC/
PLC
1595
M 4546 Tool life 2 expired (TIME2 in the tool table) NC NC/
PLC
1595
M 4547 T and G strobes with TOOL CALL NC NC 960,
1611
M 4560 NC stop (0: stop) PLC PLC 1404
M 4561 Rapid traverse PLC PLC 1404
M 4562 Memory function for axis direction keys
(MP7680 bit 0 = 1)
PLC PLC 1404
M 4563 Feed-rate enable for all axes PLC PLC 846
M 4564 NC start PLC PLC 1404
M 4570 Unit of measure for transfer with FN19 NC NC 1713
M 4571 Activation of decoded M-code transfer in
M1900 to M1999
PLC PLC 1254
M 4574 Select the traverse range (with M4575) PLC PLC 624,
1541
M 4575 Select the traverse range (with M4574) PLC PLC 624,
1541
M 4576 Disable the handwheel PLC PLC 1507
M 4577 Disabled key was pressed NC PLC 1392
M 4579 INCREMENT OFF/ON soft key NC NC 1530
M 4580 Suppress emergency stop, open all
position control loops, NC stop
PLC PLC 844,
932
Operand Description Set Reset SW version Page