HEIDENHAIN iTNC 530 HSCI - Page 709

July 2013 6.5 Tilting and swivel axes 709
Step 1a
Determining the Y1 offset:
 Position A = –90
 Set the dial gauge to 0
Step 1b
Determining the Y1 offset:
 Position A = +90
 Offset = 0.5 * determined
value
 If the determined value > 0,
then <Line no. [1] Column
COORD> = - offset
 If the determined value < 0,
<Line no. [1] Column
COORD> = - offset
Step 1c
Checking the settings for the Y1 offset:
 Position A = +90
 Activate 3-D ROT
 Set the dial gauge to 0
 Set datum Y = 0
 Position A = –90
 Probe same position again
 Display and dial gauge must read 0
0
0