HEIDENHAIN iTNC 530 HSCI - Page 711

July 2013 6.5 Tilting and swivel axes 711
Step 3
Determining the Y2 offset:
 Position A = 0
 Position C = 0 (basic setting)
 Set the dial gauge to 0
 Position C to 180
 Read Y offset from the dial
gauge
 <Line no. [4] Column
COORD> = (0.5 * determined
value) – <Line no. [1]
Column COORD>;
(<Line no. [1] Column
COORD> = Offset Y1)
Step 4
Determining the X offset:
 C = Position to –90
 Set the dial gauge to 0
 Position C = 270
 Read X offset from the dial
gauge
 <Line no. [3] Column
COORD> = 0.5 * determined
value
180°
0
180°
0