July 2013 6.5 Tilting and swivel axes 723
COORD E.g. 47.092 [mm]
or 45.05 [°]
Entry of the transformation value for linear
axes (X, Y, Z, ...) in mm or for rotary axes
(A, B, C) in degrees. The units are not
entered. The iTNC infers the units from the
axis designation entered (valid for the
Trans parameter in the KEY column).
ON/OFF 0 or 1
(1=CMO inactive
)
Activate or deactivate a definition table for
a collision-monitored object (valid for the
CMO parameter in the KEY column). This
makes it possible, for example, for a tool-
change macro to switch off monitoring of
the cabinet.
FILE Path and file
name
a
Entry of the path and file name of a
definition table for a collision-monitored
object (valid for the CMO parameter in the
KEY column).
DONTTEST Path and file
name
a
Entry of the path and file name of a
collision-monitored object (CMO), which is
not to be monitored for collision with the
CMO referenced in the FILE column (valid
for the CMO parameter in the KEY column).
TEMPCOMP Formula, e.g.
3.45e–3 * (W486
– 20)
Entry of a formula for a permanently
effective temperature compensation for
the translation given in the line. For
temperature compensation, see page 659.
DOC Comment Entry of a comment
a. File paths should be entered as absolute paths. If only the file
name is entered, the kinematics path from OEM.SYS is valid (e.g.
KINEMATIC = PLC:\Kinemat\Kinelist.TAB).
Column Input Description
To Next Page
Loading...
