Rohde & Schwarz R&S ZNA Series - Page 1039

Command reference
R&S
®
ZNA
1039User Manual 1178.6462.02 ─ 29
CALCulate:FMODel:ISD:PRESet...................................................................................1045
CALCulate:FMODel:ISD:RUN:RUN............................................................................... 1045
CALCulate:FMODel:ISD<Pt>:RUN[:STATe].....................................................................1046
CALCulate:FMODel:ISD:SCALe:ATTenuation................................................................. 1046
CALCulate:FMODel:ISD:SCALe:FREQuency..................................................................1046
CALCulate:FMODel:ISD:SCALe:FTIMe..........................................................................1046
CALCulate:FMODel:ISD:SMALlfixture............................................................................ 1046
CALCulate:FMODel:ISD:TRACe:COUPling.....................................................................1047
CALCulate:FMODel:ISD:ATTenuation:BEHavior <AttenuationBehavior>
Sets/gets the linear_2x batch mode parameter of the ISD tool
Parameters:
<AttenuationBehavior>RESonant | LINear | NONLinear
LINear
Used for linear insertion loss of test coupon (parameter value 1)
NONLinear
Used for non-linear insertion loss of test coupon (parameter
value 2)
RESonant
The 2x thru test coupon will be split and used directly for deem-
bedding (parameter value 3).
This option may be more accurate when the fixture and 2x Thru
have the same impedance at every location
Manual operation:
See "Test Coupons > Insertion Loss" on page 737
CALCulate:FMODel:ISD:COUPon:MEASure
For a fixture modeling with the ISD tool and coupon types SYMMetric2x | OPEN1x |
SHORt1x (see CALCulate:FMODel:ISD:COUPon:TYPE), this command starts the
measurement of the coupon at the active ports (see CALCulate:FMODel:
ISD<Ph_pt>:COUPon[:STATe]).
Example:
See Chapter 8.2.9, "Fixture modeling", on page 1762
Usage: Event
Manual operation: See "Measure / Measure Open / Measure Short" on page 731
CALCulate:FMODel:ISD:COUPon:MEASure:FILename <String>
For a fixture modeling with the ISD tool and coupon types SYMMetric2x | OPEN1x |
SHORt1x (see CALCulate:FMODel:ISD:COUPon:TYPE), this command loads the
coupon properties from a Touchstone file.
Parameters:
<String> Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
SCPI command reference