Rohde & Schwarz R&S ZNA Series - Page 1040

Command reference
R&S
®
ZNA
1040User Manual 1178.6462.02 ─ 29
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset" on page 732
CALCulate:FMODel:ISD:COUPon:MEASure:FILename:CLEar
Invalidates the file path previously set using CALCulate:FMODel:ISD:DUT:
MEASure:FILename, CALCulate:FMODel:ISD:COUPon:MEASure:OPEN:
FILename, or CALCulate:FMODel:ISD:COUPon:MEASure:SHORt:FILename.
Usage: Event
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset" on page 732
CALCulate:FMODel:ISD:COUPon:MEASure:OPEN
For a fixture modeling with the ISD tool and coupon type OPSHort1x (see
CALCulate:FMODel:ISD:COUPon:TYPE), this command starts the measurement of
the Open coupon at the active ports (see CALCulate:FMODel:ISD<Ph_pt>:
COUPon[:STATe]).
Usage:
Event
Manual operation: See "Measure / Measure Open / Measure Short" on page 731
CALCulate:FMODel:ISD:COUPon:MEASure:OPEN:FILename <String>
For a fixture modeling with the ISD tool and coupon type OPSHort1x (see
CALCulate:FMODel:ISD:COUPon:TYPE), this command loads the properties of the
Open coupon from a Touchstone file.
Parameters:
<String> Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset" on page 732
CALCulate:FMODel:ISD:COUPon:MEASure:SHORt
For a fixture modeling with the ISD tool and coupon type OPSHort1x (see
CALCulate:FMODel:ISD:COUPon:TYPE), this command starts the measurement of
the Short coupon at the active ports (see CALCulate:FMODel:ISD<Ph_pt>:
COUPon[:STATe]).
Usage:
Event
Manual operation: See "Measure / Measure Open / Measure Short" on page 731
CALCulate:FMODel:ISD:COUPon:MEASure:SHORt:FILename <String>
For a fixture modeling with the ISD tool and coupon type OPSHort1x (see
CALCulate:FMODel:ISD:COUPon:TYPE), this command loads the properties of the
Short coupon from a Touchstone file.
SCPI command reference