Rohde & Schwarz R&S ZNA Series - Page 1043

Command reference
R&S
®
ZNA
1043User Manual 1178.6462.02 ─ 29
Corresponds to the active_dut batch mode parameter of the ISD tool.
Parameters:
<DUTType> PASSive | ACTive
Manual operation: See "DUT Type" on page 738
CALCulate:FMODel:ISD:FTIMe:DUT <FltDutAndLeadIns>
If CALCulate:FMODel:ISD:FTIMe:OVERride is set to TRUE, this command allows
to set the flight time for DUT + Lead-ins manually.
This is equivalent to setting the leadin_dut_time batch mode parameter of the ISD
tool to a numeric value (not auto).
Parameters:
<FltDutAndLeadIns> Default unit: s
Manual operation: See "DUT + lead-ins flight time" on page 738
CALCulate:FMODel:ISD:FTIMe:OVERride <Boolean>
If set to true, the flight time for DUT + lead-in is specified using CALCulate:FMODel:
ISD:FTIMe:DUT. Otherwise, it is calculated automatically.
True is equivalent to setting the leadin_dut_time batch mode parameter of the ISD
tool to auto.
Parameters:
<Boolean>
Manual operation: See "Auto. flight time for DUT + lead-Ins" on page 738
CALCulate:FMODel:ISD:IMPedance <Boolean>
Enables/disables the impedance correction of the ISD tool.
This is a global setting.
Parameters:
<Boolean> ON (1)
Impedance correction enabled
OFF (0)
Impedance correction disabled
Manual operation: See "Use Impedance Correction" on page 730
CALCulate:FMODel:ISD:OPERation <Operation>
Defines the execution mode of the ISD tool.
SCPI command reference