Command reference
R&S
®
ZNA
1110User Manual 1178.6462.02 ─ 29
'NF1R' | 'NF2R' | ... Receiver noise figure, as measured in noise figure channels
Requires option R&S ZNA-K30.
'SA1' | 'SA2' | ... Spectrum trace at the measurement receiver of port 1, 2, ...
Requires option R&S ZNA-K1.
'SA1REF' | 'SA2REF' | ... Spectrum trace at the reference receiver of port 1, 2, ...
Requires option R&S ZNA-K1.
'CmpPtPin' | 'CmpPtPout' | 'CmpPtS' Compression point traces for gain compression measurements:
power in | power out | S-param
''H<order>B<recPort>[R|THDF|THDR]'
''H<order>B<recPort>D<drvPort>)[R|THDF|THDR]'
Harmonic measurement with:
●
Order <order>
●
Receive port <recPort>
●
Drive port <drvPort> (if omitted, 1 is assumed)
●
Relative, THD
F
, THD
R
, or direct (if omitted)
See Chapter 5.2.4, "Ratio | Harmonics tab", on page 361.
MixDly | MixPhas | MixDeriv Delay, phase and derivative for two-tone group delay measurements
(R&S ZNA-K9)
Mix_a_LTone | Mix_a_UTone | Mix_b_LTone |
Mix_b_UTone
Main tones (Lower/Upper) at input (a) or output (b) for two-tone group delay
measurements (R&S ZNA-K9)
Cu(P<Src Port>)<_lowercase_ext_dll_name>/<Task
Traces calculated using external DLL <ext_dll_name>.dll.
*) Selecting a parameter Y...<n><m> or Z...<n><m> sets the range of port numbers to
be considered for the Y and Z-parameter measurement to <n>:<m>.
CALCulate<Ch>:PARameter:SDEFine:SENDed <TraceName>, <Result>
Creates a trace and assigns a channel number, a name and a measurement parame-
ter to it. The trace becomes the active trace in the channel but is not displayed.
Similar to CALCulate<Ch>:PARameter:SDEFine, but in presence of balanced ports
this command distinguishes between
●
single-ended S-parameters for logical ports (SSS<Li><Lj>)
●
"raw" single-ended S-parameters referring to physical ports (S<Pi><Pj>)
Suffix:
<Ch>
.
Channel number
Setting parameters:
<TraceName> Trace name
<Result> Measured quantity
Usage: Setting only
Manual operation: See "S-Parameter (selector)" on page 345
SCPI command reference
To Next Page
Loading...
