Command reference
R&S
®
ZNA
1305User Manual 1178.6462.02 ─ 29
Manual operation: See "Export Test Results" on page 822
MMEMory:STORe:EYE:MEASurements <TraceName>, <TraceFile>[,
<DecSeparator>[, <FieldSeparator>]]
Allows to export eye diagram results to an ASCII file (csv), with the possibility to spec-
ify a decimal separator (comma or point) and a field separator (semicolon, comma, tab
or space).
See also CALCulate<Chn>:EYE:MEASurement:DATA? on page 1007.
Note that the decimal separator and field separator must be different: if both are set to
comma, actually a semicolon will be used as field separator.
Setting parameters:
<TraceName> The name of the eye diagram whose results shall be exported
<TraceFile> Mandatory string parameter containing the path and file name of
the file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
<DecSeparator> POINt | COMMa
Decimal separator
*RST: COMMa
<FieldSeparator> SEMicolon | COMMa | TABulator | SPACe
Field separator
*RST: SEMicolon
Usage: Setting only
Options: R&S ZNA-K20
Manual operation: See "Export Measurements..." on page 808
MMEMory:STORe:LIMit <TraceName>, <LimLineFile>
Saves the limit lines associated to a specified trace to a limit line file. Limit lines are
created using the CALCulate<Chn>:LIMit... commands.
Setting parameters:
<TraceName> Name of an existing trace in the active recall set (string parame-
ter) for which a limit line definition exists.
<LimLineFile> String parameter to specify the name and directory of the cre-
ated limit line file. The default extension (manual control) for limit
line files is *.limit, although other extensions are allowed.
If no path is specified the analyzer searches the current direc-
tory, to be queried with MMEMory:CDIRectory
Example: See MMEMory:LOAD:LIMit
Usage: Setting only
Manual operation: See "Recall... / Save..." on page 484
SCPI command reference
To Next Page
Loading...
