Rohde & Schwarz R&S ZNA Series - Page 1304

Command reference
R&S
®
ZNA
1304User Manual 1178.6462.02 ─ 29
(parameter omitted)
If the parameter is omitted, the command refers to the two-port
selected using SOURce<Ch>:POWer<PhyPt>:CORRection:
TCOefficient:CALibration.
Setting parameters:
<PmclFile> String parameter specifying the name and directory of the cre-
ated power meter correction list file. The file extension *.pmcl
is mandatory.
If no path is specified, the analyzer searches the current direc-
tory, to be queried with MMEMory:CDIRectory
*RST: n/a
Example: See SOURce:POWer:CORRection:TCOefficient[:STATe]
Usage: Setting only
Manual operation: See "Recall... / Save..." on page 634
MMEMory:STORe:EYE:MASK <TraceName>, <TraceFile>
Stores a user-defined eye mask to a 7bit ASCII file.
Setting parameters:
<TraceName> Name of the related eye diagram
<TraceFile> String parameter containing the path and file name of the eye
mask file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNA-K20
Manual operation: See "Save / Load Mask Configuration" on page 825
MMEMory:STORe:EYE:MASK:RESults <TraceName>, <TraceFile>
Saves the detailed results of the mask test in the related eye diagram to an ASCII file
(see CALCulate<Chn>:EYE:MASK:DATA? on page 1001).
This command will raise an execution error if CALCulate<Chn>:EYE:MASK:STATe is
OFF.
Setting parameters:
<TraceName> The name of the eye diagram whose mask test results shall be
exported
<TraceFile> Mandatory string parameter containing the path and file name of
the file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNA-K20
SCPI command reference