Rohde & Schwarz R&S ZNA Series - Page 1390

Command reference
R&S
®
ZNA
1390User Manual 1178.6462.02 ─ 29
Parameter Type (GUI)
VUOSm UOSM Vector Mixer
TRL | TOM | TSM | TRM | TNA TRL | TOM | TSM | TRM | TNA
ARPTosm | POPTport | PTOSm |
PUOSm | VPUosm | PTRL | PTOM |
PTSM | PTRM | PTNA
One of the previous n-port calibration types, in combination with a
receiver power calibration at test port <TestPort1> (SMARTerCal)
PFTRans, PRTRans, PFRTrans FTRans, RTRans, in combination with a receiver power calibration
at the source port(s)
PREFl, PRSHort, PFOPort REFl, RSHort, FOPort, in combination with a receiver power cali-
bration at all ports
PRRCv Reference receiver power calibration at all ports
CPUOsm PUOSM Scalar Vector Mixer
MTOSm | MUOSm | MOSM | MTRL METAS Calibration of type OSM, UOSM, OSM, or TRL
MDELay Mixer Delay
Delay mixer calibration (stand-alone) for two-tone group delay
measurements
UMDelay UOSM Mixer Delay calibration
UOSM combined with delay mixter calibration for two-tone group
delay measurements (R&S ZNA-K9)
PUMDelay UMDelay calibration with complementary source flatness cal for
two-tone group delay measurements (R&S ZNA-K9)
[SENSe<Ch>:]CORRection:COLLect:NFIGure[:ACQuire] <arg0>
Starts one of the three noise calibration sweeps that are required for a noise figure cali-
bration of the related channel.
The noise figure calibration is initiated using [SENSe<Ch>:]CORRection:COLLect:
NFIGure:STARt and must be terminated by one of the commands [SENSe<Ch>:
]CORRection:COLLect:NFIGure:END or [SENSe<Ch>:]CORRection:
COLLect:NFIGure:SAVE.
Note: A noise figure calibration must be terminated with one of the following com-
mands, to be sent immediately after the sequence of ...[:ACQuire] commands:
●
Abort the noise figure calibration, discarding the acquired calibration data.
●
Terminate the noise figure calibration, applying the acquired calibration data (the
active channel is calibrated) These commands ensure that the analyzer is able to
start a new measurement sweep.
Suffix:
<Ch>
.
Number of the channel to be noise figure calibrated.
The other noise figure calibration commands must use the same
channel number.
Setting parameters:
<arg0> RECeiver | SOURce | ATTenuator
SCPI command reference