Rohde & Schwarz R&S ZNA Series - Page 1430

Command reference
R&S
®
ZNA
1430User Manual 1178.6462.02 ─ 29
Parameters:
<Converter Type> String value, e.g. 'ZVA-Z110'; use [SENSe:]CONVerter:
DEFinition:CATalog? to get the list of converter types. An
empty string '' indicates that no converter is connected.
Options: R&S ZNA-K8
Manual operation: See "Converter Type" on page 902
[SENSe<Ch>:]FREQuency:CONVersion:GAIN:LMCorrection <Boolean>
Enables or disables load match correction for frequency transmission S-parameters
(conversion gain factors in case of frequency-converting measurements).
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> *RST: ON
Example: See SOURce<Ch>:FREQuency<PhyPt>:CONVersion:
ARBitrary:IFRequency
Manual operation: See "Load Match Correction" on page 636
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:FIXed<Stg> <InputOutput>
Selects the mixer input or output signal which is at the fixed frequency defined via
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:MFFixed.
Suffix:
<Ch>
.
Channel number.
<Stg> Counter for fixed signal (1 if only one mixer stage is used, 1 or 2
for 2 mixer stages).
Parameters:
<InputOutput> RF | LO | LO1 | LO2 | IF
RF - mixer input signal
LO | LO1 | LO2 - local oscillator signal 1 or 2 (for 2-stage mixer
measurements, see [SENSe<Ch>:]FREQuency:
CONVersion:MIXer:STAGes)
IF - mixer output signal (mixing product)
*RST: LO
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
SCPI command reference