Rohde & Schwarz R&S ZNA Series - Page 1531

Command reference
R&S
®
ZNA
1531User Manual 1178.6462.02 ─ 29
Parameters:
<Frequency> Frequency of the CW signal
*RST: 1 GHz
Default unit: Hz
Manual operation: See "Frequency / Power" on page 921
SOURce:INDependent<Pt>:OFF <RF off>
If RF port <Pt> is configured as an independent CW source (SOURce:
INDependent<Pt>[:STATe] ON), this command toggles the CW signal.
Suffix:
<Pt>
.
VNA RF port number
Parameters:
<RF off> ON (1)
The independent CW source is switched off.
OFF (0)
The independent CW source is switched on.
*RST: OFF (0)
Manual operation: See "Source RF Off" on page 921
SOURce:INDependent<Pt>:POWer <Power>
If RF port <Pt> is configured as an independent CW source (SOURce:
INDependent<Pt>[:STATe] ON), this command sets the power of the CW signal.
Suffix:
<Pt>
.
VNA RF port number
Parameters:
<Power> Power of the CW signal
*RST: -10 dBm
Default unit: dBm
Manual operation: See "Frequency / Power" on page 921
SOURce:INDependent<Pt>[:STATe] <Active>
Defines whether port <Pt> operates as independent CW source
Suffix:
<Pt>
.
VNA port number
Parameters:
<Active> ON (1)
Port <Pt> operates as independent CW source.
OFF (0)
Port <Pt> can be used as driving port in VNA channels.
SCPI command reference