Rohde & Schwarz R&S ZNA Series - Page 899

GUI reference
R&S
®
ZNA
899User Manual 1178.6462.02 ─ 29
– Self test error
In this case enable error logging for external devices (see "Log Errors"
on page 891), and search the Error Log tab for self test error codes of the
device.
●
– The device driver does not match exactly the device type. Probably the device
cannot be controlled properly. Measurements results are questionable.
Remote command:
SYSTem:COMMunicate:RDEVice:GENerator<Gen>:DEFine
SYSTem:COMMunicate:RDEVice:GENerator:DELete
SYSTem:COMMunicate:RDEVice:GENerator<Gen>:CATalog?
SYSTem:COMMunicate:RDEVice:GENerator<Gen>:DEFine
SYSTem:COMMunicate:RDEVice:GENerator<Gen>:SEPMode
SYSTem:COMMunicate:RDEVice:GENerator<Gen>:SEPower
Scan Instruments
Performs an autodetection of "Known Devices" on the supported interfaces.
Note: Unintentional switchover to remote control
When using the NI-VISA library, ensure that the network analyzer itself is not listed as
a network device in the Measurement & Automation Explorer. Otherwise, "Scan Instru-
ments" will send an identification query (*IDN?), causing the analyzer to close the
"External Generators" dialog (without executing "Scan Instruments") and to activate the
remote screen.
Remote command:
n/a
LAN Detection
Activate "LAN Detection" to include the LAN interface in the autodetection sequence
(see Scan Instruments).
Note: "LAN detection" will only work for external devices sharing the same IP subnet
with the R&S ZNA.
As a prerequisite, the R&S ZNA must accept incoming connections on UDP port 2473.
If necessary, add a corresponding inbound rule to your firewall settings.
Remote command:
n/a
Add Device
Adds a new instrument to the list of "Configured Devices". In the "Add External Gener-
ator" dialog opened, you can specify the properties of the new instrument and the con-
nection.
Setup softtool