Command Reference Link Checking Commands
no schedule session num time-range time-range period day1 [to day2] time hh1:mm1 [to
hh2:mm2]
Parameter
Description
Parameter Description
num
Specifies the ID of the scheduling session for which a scheduling
period is set. The range is from 1 to 64.
time-range
Time range ID. The range is from 1 to 4.
day1
Specifies the starting day of the period.
The value can be Sunday, Monday, Tuesday, Wednesday, Thursday,
Friday, or Saturday.
day2
Specifies the end day of the period.
The value can be Sunday, Monday, Tuesday, Wednesday, Thursday,
Friday, or Saturday.
hh1:mm1
Specifies the start time for scheduling. The range is from 00:00 to
24:00.
hh2:mm2
Specifies the end time for scheduling. The range is from 00:00 to
24:00.
no
Deletes the scheduling period.
Defaults
No scheduling period is set for a scheduling session by default.
Command
mode
Global configuration mode
Usage Guide
You can run this command for many times. The configuration at the last time overwrites that at the
previous time.
Configuration
Examples
The following example creates scheduling session 1 and sets the scheduling period.
Ruijie(config)# schedule session 1
Ruijie(config)# schedule session 1 time-range 1 period mon to fri time 00:00
to 10:00
Ruijie(config)# schedule session 1 time-range 2 period sat to sun time 10:00
to 12:00
Related
Commands
Command Description
show schedule session
Checks configuration information about the
scheduling session.
Platform
Description
This command is supported only on wireless AC and fat AP series.
To Next Page
Loading...
Need help?
General
