Ruijie RG-WLAN Series

Command Reference NFPP Commands
Related
Commands
Command Description
nfpp nd-guard policy
Set the rate limit and the attack threshold.
show nfpp nd-guard summary
Show the configurations.
Platform
Description
N/A
nfpp arp-guard enable
Use this command to enable the anti-ARP attack function on the interface.
nfpp arp-guard enable
Parameter
Description
Parameter Description
N/A N/A
Defaults
The anti-ARP attack function is not enabled on the interface.
Command
Mode
Interface configuration mode.
Usage Guide
The interface anti-ARP attack configuration is prior to the global configuration.
Configuration
Examples
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp arp-guard enable
Related
Commands
Command Description
arp-guard enable
Enable the anti-ARP attack function.
show nfpp arp-guard summary
Show the configurations.
Platform
Description
N/A
nfpp arp-guard isolate-period
Use this command to set the isolate period in the interface configuration mode
nfpp arp-guard isolate-period { seconds | permanent }
Parameter
Description
Parameter Description
seconds
Set the isolate period, in second. The valid range is 0, or [30, 86400].