Command Reference i-Share Antenna Feeder Commands
i-Share Antenna Feeder Commands
antdetect enable
Use this command to enable feeder link detection function. Use the no form of this command to
restore to the default value.
antdetect enable
no antdetect enable
Parameter
Description
Parameter Description
N/A N/A
Defaults
Disabled
Command
Mode
AP-Config Configuration Mode
Usage Guide
N/A
Configuration
Examples
The following example enables I-share antenna feeder link detection function:
ruijie(config-ap)#antdetect enable
Related
Commands
Command Description
N/A N/A
Platform
Description
This command is supported only in RGOS10.4(1T19) and the laters. This command is supported only
on the AP220-E(M) v3.0 and above.
show antenna all
Use this command to display feeder status of all APs.
show antenna all
Parameter
Description
Parameter Description
N/A N/A
Defaults
N/A