Ruijie RG-WLAN Series - Arp-Guard Scan-Threshold

Command Reference NFPP Commands
pps
Set the rate limit, in the range of 1 to 9999
Defaults
The default rate limit for each source IP address and MAC address is 4pps; the default rate limit for
each port is 100pps.
Command
Mode
NFPP configuration mode.
Usage Guide
N/A
Configuration
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard rate-limit per-src-ip 2
Ruijie(config-nfpp)# arp-guard rate-limit per-src-mac 3
Ruijie(config-nfpp)# arp-guard rate-limit per-port 50
Related
Commands
Command Description
nfpp arp-guard policy
Set the rate limit and the attack threshold.
show nfpp arp-guard summary
Show the configurations.
Platform
Description
N/A
arp-guard scan-threshold
Use this command to set the global scan threshold.
arp-guard scan-threshold pkt-cnt
Parameter
Description
Parameter Description
pkt-cnt
Set the scan threshold, in the range of 1 to 9999.
Defaults
The default scan threshold is 15, in 10 seconds.
Command
Mode
NFPP configuration mode
Usage Guide
The scanning may occur on the condition that:
more than 15 packets are received within 10 seconds;
the source MAC address for the link layer is constant while the source IP address is uncertain;
the source MAC and IP address for the link layer is constant while the destination IP address is
uncertain.
Configuration
Ruijie(config)# nfpp