Ruijie RG-WLAN Series

Command Reference WLAN-WLOG Commands
WLAN-WLOG Commands
wlan diag enable
Use this command to enable the WLAN-WLOG function on ACs and APs. Use the no form of this
command to disable this function.
wlan diag enable
no wlan diag enable
Parameter
Description
Parameter Description
N/A N/A
Defaults
The WLAN-WLOG function is disabled on ACs and APs.
Command
mode
Global configuration mode
Usage Guide
The memory pre-allocation is performed when the WLAN-WLOG function is enabled. If the memory is
insufficient, the WLAN-WLOG function cannot be enabled.
Memories of all saved information and pre-allocated memories are reclaimed when the WLAN-WLOG
function is disabled.
Configuration
Examples
The following example shows how to enable or disable the WLAN-WLOG function:
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#wlan diag enable
Ruijie(config)#no wlan diag enable
Related
Commands
Command Description
N/A N/A
Platform
Description
This command is supported on ACs and APs in WLANs.
show wlan diag sta
Use the following command to display terminal statistics on an AC:
show wlan diag sta [ sta-mac STA_MAC ] [ ip-range IP_PREFIX ] [ action ACTION [ result
RESULT ] ] [ number NUMBER ]