Ruijie RG-WLAN Series

Command Reference NFPP Commands
nfpp dhcpv6-guard isolate-period
Use this command to set the isolate period in the interface configuration mode.
nfpp dhcpv6-guard isolate-period { seconds | permanent }
Parameter
Description
Parameter Description
seconds
Set the isolate period, in second. The valid range is 0, or [30, 86400].
0 indicates no isolation.
permanent Permanent isolation.
Defaults
By default, the isolate period is not configured.
Command
Mode
Interface configuration mode.
Usage Guide
N/A
Configuration
Examples
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp dhcpv6-guard isolate-period 180
Related
Commands
Command Description
dhcpv6-guard isolate-period
Set the global isolate period.
show nfpp dhcpv6-guard summary
Show the configurations.
Platform
Description
N/A
nfpp icmp-guard enable
Use this command to enable the ICMP anti-attack function on the interface.
nfpp icmp-guard enable
Parameter
Description
Parameter Description
N/A N/A
Defaults
The ICMP anti-attack function is not enabled on the interface.
Command
Mode
Interface configuration mode.