Ruijie RG-WLAN Series Rgos Command Reference

Command Reference WLAN-VLAN Mapping Commands
WLAN-VLAN Mapping Commands
vlan-assign-mode
Use this command to set a VLAN assignment mode for the current or all VLAN groups on an AP
device. Use the no form of this command to remove the setting.
vlan-assign-mode dot1x
no vlan-assign-mode
Parameter Description
Parameter
Description
dot1x
Indicates that the authentication server is responsible for
assigning VLANs to users that pass 802.1x
authentication.
Defaults
No VLAN assignment mode is specified.
Configuration
Mode
VLAN group configuration mode or global configuration mode
Usage Guide
The VLAN assignment mode set in global configuration mode takes effect on all VLAN groups.
The VLAN assignment mode set in VLAN group configuration mode takes effect only on the
current VLAN group.
The VLAN assignment mode set in VLAN group configuration mode prevails over that set in
global configuration mode.
Configuration
Examples
The following example shows how to configure the 802.1x-based VLAN assignment mode for
VLAN group 100 on an AP.
Ruijie# configure terminal
Ruijie(config)# vlan-group 100
Ruijie(config-vlan-group)# vlan-assign-mode dot1x
Command Description
Related
Commands
show vlan-group [group-id]
Display information about a VLAN group.
Platform
Description
This command is supported by the RGOS10.4 (1T17) or later versions.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English