Command Reference Web Authentication Commands
Web Authentication Commands
http redirect
In global configuration mode, use this command to configure the IP address of the HTTP redirection,
which is the IP address of the first generation Portal server deployed on the network. Use the no form
of this command to remove the IP address of the HTTP redirection.
http redirects ip-address
no http redirect
Parameter
Description
Parameter Description
ip-address
The IPv4 address of the HTTP redirection.
Defaults
By default, the IP address of the HTTP redirection is not configured.
Command
mode
Global configuration mode
Usage Guide
This command configuration is for the first generation Web authentication Portal server address, not
for the second generation Web authentication.
Configuration
Examples
#Designate the IPv4 address of the HTTP redirection as 172.16.0.1.
Ruijie(config)# http redirect 172.16.0.1
Related
Commands
Command Description
show http redirect
Shows the configurations of HTTP redirection.
http redirect homepage
Sets the homepage IP address of the
authentication page.
Platform
Description
N/A
http redirect direct-site
Use this command to set the scope of authentication-free network resources. Use the no form of this
command to delete the scope of authentication-free network resources.
http redirects direct-site ipv6-address | { ip-address [ ip-mask ] [ arp ] }
no http redirects direct-site ipv6-address | { ip-address [ ip-mask ] }