Ruijie RG-WLAN Series Rgos Command Reference

Command Reference ACL Commands
reflect
Enable the Reflexive-ACL.
Defaults
No ACL is applied on the interface.
Command
mode
Interface configuration mode.
Usage Guide Use the ip access-group command to apply the specified ACL to the interface, when the firewall is
enabled.
Configuration
Examples
The following example applies the ACL 120 on the fastEthernet0/0 to filter the incoming packets:
Ruijie(config)# interface fastEthernet 0/0
Ruijie(config-if)# ip access-group 120 in
Related
Commands
Command Description
access-list
Define the ACL.
show access-lists
Show all the ACLs.
Platform
Description
N/A
ip access-list
Use this command to create a standard IP ACL or extended IP ACL. Use the no form of the
command to remove the ACL.
ip access-list {extended | standard} {id | name}
no ip access-list {extended | standard} {id | name}
Parameter
Description
Parameter Description
id
ID of the ACL 1 to 99 and 1300 to 1999 for standard ACL) or 100 to
199 and 2000 to 2699 for extended ACL
name
Name of the ACL
Defaults
None
Command
mode
Global configuration mode.
Usage Guide
There are differences between a standard ACL and an extended ACL. The extended ACL is more
precise. Refer to deny or permit in the two modes. Use show access-lists to display the ACL
configurations.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English