Ruijie RG-WLAN Series Rgos Command Reference

Command Reference IP Address Commands
Usage Guide
When the route is not optimal, it may cause the device to receive packets through one interface and
send it though the same interface. If the device sends the packet from the same interface through
which this packet is received, the device will send an ICMP redirection message to the data source,
telling the data source that the gateway for the destination address is another device in the subnet. In
this way, the data source will send subsequent packets along the optimal path.
The RGOS software enables ICMP redirection by default.
Configuration
Examples
The following example disables ICMP redirection on the FE interface 0/1.
interface fastEthernet 0/1
no ip redirects
Related
Commands
Command Description
N/A N/A
Platform
Description
This command is not supported on Layer 2 switches.
ip source-route
Use this command to allow the RGOS software to process an IP packet with source route information
in global configuration mode. Use the no form of this command to disable the source route
information processing function.
ip source-route
no ip source-route
Parameter
Description
Parameter Description
N/A N/A
Defaults
The function is enabled.
Command
Mode
Global configuration mode
Usage Guide
RGOS supports IP source routes. When the device receives an IP packet, it will check the options of
the IP packet, such as strict source route, loose source route and record route. Details about these
options can be found in RFC 791. If an option is found to be enabled in this packet, a response will be
made. If an invalid option is detected, an ICMP parameter error message will be sent to the data
source, and then this packet is discarded.
The RGOS software supports IP source routes by default.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English