Command Reference ACL Commands
Parameter
Description
Parameter Description
N/A N/A
Defaults
N/A
Command
mode
Interface configuration mode.
Usage Guide
Use this command to configure the uplink port of the security channel on the interface.
Configuration
Examples
Ruijie(config-if)#security uplink enable
Related
Commands
Command Description
show running
Show configuration of current system.
Platform
Description
This command is not supported by routers.
show access-group
Use this command to show the ACL configured on the interface.
show access-group [ interface interface ]
Parameter
Description
Parameter Description
interface
Interface ID
Defaults
N/A
Command
mode
Privileged EXEC mode
Usage Guide
Show the ACL configured of the interface. If no interface is specified, the associated ACLs of all the
interfaces will be shown.
Configuration
Examples
Ruijie# show access-group
ip access-list standard ipstd3
Applied On interface GigabitEthernet 0/1.
ip access-list standard ipstd4
Applied On interface GigabitEthernet 0/2.
ip access-list extended 101