Ruijie RG-WLAN Series - Webauth Prevent-Jitter

Command Reference Wireless Security Commands
Examples
to AES.
Ruijie (config)#wlansec 1
Ruijie(wlansec)# security wpa ciphers aes enable
The following example disables the AES encryption method for WLAN1 in the WPA authentication
mode.
Ruijie (config)#wlansec 1
Ruijie(wlansec)# security wpa ciphers aes disable
The following example configures the encryption method for WLAN1 in the WPA authentication mode
to TKIP.
Ruijie (config)#wlansec 1
Ruijie(wlansec)# security wpa ciphers tkip enable
The following example disables the TKIP encryption method for WLAN1 in the WPA authentication
mode.
Ruijie (config)#wlansec 1
Ruijie(wlansec)# security wpa ciphers tkip disable
Related
Commands
Command Description
security wpa { enable | disable }
Configures the WLAN configuration mode.
security wpa akm { psk | 802.1x } { enable |
disable }
Configures an authentication method in the
WPA authentication mode.
security wpa akm psk set-key ascci
Configures a shared password in the WPA
authentication mode.
Platform
Description
N/A
webauth prevent-jitter
Use this command to set the timeout for jitter prevention during Web authentication of a particular
WLAN. Use the no or default form of this command to restore the default setting.
webauth prevent-jitter timeout
Parameter
Description
Parameter Description
timeout
Sets the timeout for jitter prevention during Web
authentication. The range is from 0 to 86400 seconds.
no/default Restores the default value of 300 seconds.
Defaults
N/A
Command
mode
WLAN security configuration mode.