Ruijie RG-WLAN Series

Command Reference 802.1X Commands
dot1x auto-req packet-num
Use this command to set the number of authentication request messages that the device
automatically sends. The no form is used to specify the default value.
dot1x auto-req packet-num num
no dot1x auto-req packet-num
Parameter
Description
Parameter Description
num
Number of authentication request messages that the device sends
automatically.
Defaults
num = 0; namely the packets are sent continuously
Command
Mode
Global configuration mode.
Usage Guide
Use the show dot1x auto-req command to view the setting of this function.
Configuration
Examples
The following example sets the device to automatically initiate 802.1x authentication continuously:
Ruijie# configure terminal
Ruijie(config)# dot1x auto-req packet-num 0
Ruijie(config)# end
Ruijie# show dot1x auto-req
Auto-Req: Enabled
User-Detect : Enabled
Packet-Num : 0
Req-Interval: 30 Second
Related
Commands
Command Description
show dot1x auto-req
Shows the automatic authentication request
information.
Platform
Description
N/A