Ruijie RG-WLAN Series Rgos Command Reference

Command Reference DHCP Snooping Commands
ip dhcp snooping bootp-bind
Use this command to enable DHCP snooping bootp bind function. The no form of this command will
disable the function.
ip dhcp snooping bootp-bind
no ip dhcp snooping bootp-bind
Parameter
Description
Parameter Description
N/A. N/A.
Defaults
Disabled
Command
Mode
Global configuration mode.
Usage Guide
By default, the DHCP Snooping only forwards Bootp packets. With this function enabled, it can snoop
Bootp packets. After the Boop client requests an address successfully, the DHCP Snooping adds the
Bootp user to the static binding database.
Configuration
Examples
The following example enables the DHCP snooping bootp bind function.
Ruijie# configure terminal
Ruijie(config)# ip dhcp snooping bootp-bind
Ruijie(config)# end
Ruijie# show ip dhcp snooping
Switch DHCP snooping status :ENABLE
Verification of hwaddr field status :DISABLE
DHCP snooping database write-delay time: 0 seconds
DHCP snooping option 82 status: ENABLE
DHCP snooping Support Bootp bind status: ENABLE
Interface Trusted Rate limit (pps)
------------------------ ------- ------------
Related
Commands
Command Description
show ip dhcp snooping
Show the configuration of the DHCP snooping.
Platform
Description
N/A.
ip dhcp snooping database write-delay
Use this command to configure the switch to write the dynamic user information of the DHCP

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English