Ruijie RG-WLAN Series Rgos Command Reference

Command Reference IPv6 Commands
ipv6 address autoconfig
Use this command to automatically configure an IPv6 stateless address for a network interface. Use
the no form of this command to delete the auto-configured address.
ipv6 address autoconfig[default]
no ipv6 address autoconfig
Parameter Description Parameter
Description
default
(Optional) If this keyword is configured, a default routing is generated. Note that only
one layer3 interface on the entire device is allowed to use the default keyword
Defaults
N/A
Command
Mode
Interface configuration mode
Usage Guide
The stateless automatic address configuration is that when receiving the RA (Route Advertisement)
message, the device could use the prefix information of the RA message to automatically generate
the EUI-64 interface address.
If the RA message contains the flag of the “other configurations”, the interface will obtain these “other
configurations” through the DHCPv6. The “other configurations” usually means the IPv6 address of
the DNS server, the IPv6 address of the NTP server, etc.
Use the no ipv6 address autoconfig command to delete the IPv6 address.
Configuration
Examples
Ruijie(config-if)# ipv6 address autoconfig default
Ruijie(config-if)# no ipv6 address autoconfig
Command Description Related
Commands
ipv6 address ipv6-prefix/prefix-length [eui-64]
Configure the IPv6 address for the interface
manually.
Platform
Description
N/A
ipv6 enable
Use this command to enable the IPv6 function on an interface. Use the no form of this command to
disable this function.
ipv6 enable
no ipv6 enable
Parameter Description Parameter
Description
N/A N/A

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English