Ruijie RG-WLAN Series Rgos Command Reference

Command Reference SNMP Commands
Examples
Ruijie(config)# snmp-server trap-timeout 60
Related
Commands
Command Description
snmp-server queue-length
Specifies the length of the SNMP trap message
queue.
snmp-server enable host
Specifies the NMS host
Platform
Description
N/A
snmp-server user
Use this command to set the SNMP user in global configuration mode. Use the no form of this
command to delete the user.
snmp-server user username groupname { v1 | v2 | v3 [ encrypted ] [ auth { md5 | sha }
auth-password ] [ priv des56 priv-password ] } [ access { [ ipv6 ipv6_aclname ] [ aclnum |
aclname } ] ]
no snmp-server user username groupname { v1 | v2c | v3 }
Parameter
Description
Parameter Description
username
User name
groupname
Group name of the user.
v1 | v2 | v3
SNMP Version. But only SNMPv3 supports the following security
parameters.
encrypted
Input the password in cipher text mode.
In cipher text mode, input consecutive HEX alphanumeric characters.
Note that the authentication password of MD5 has a length of 16
bytes, while that of SHA has a length of 20 bytes. Two characters
make a byte. The encrypted key can only be used by the local SNMP
engine on the switch.
auth
Specifies whether to use the authentication.
md5
Enables the MD5 authentication protocol. While the sha enables the
SHA authentication protocol.
auth-password
Password string (no more than 32 characters) used by the
authentication protocol. The system will change the password to the
corresponding authentication key.
priv
Specifies whether to use the encryption. des56 refers to 56-bit DES
encryption protocol.
priv-password
Password string (no more than 32 characters) used for encryption.
The system will change the password to the corresponding
encryption key.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English