Ruijie RG-WLAN Series Rgos Command Reference

Command Reference SNMP Commands
snmp-server group
Use this command to set the SNMP user group in the global configuration mode. The no form of this
command is used to remove the user group.
snmp-server group groupname { v1 | v2c | v3 { auth | noauth | priv } } [ read readview ] [ write
writeview ] [ access { ipv6 ipv6-aclname | aclnum | aclname } ]
no snmp-server group groupname { v1 | v2c | v3 { auth | noauth | priv } }
Parameter
Description
Parameter Description
v1 | v2c | v3
Specifies SNMP Version.
auth
Authenticates the messages transmitted by the user group without
encryption. This applies to only SNMPv3.
noauth
Neither authenticate nor encrypt the messages transmitted by the
user group. This applies only to SNMPv3.
priv
Authenticates and encrypts the messages transmitted by the user
group. This applies only to SNMPv3.
readview
Associates with a read-only view.
writeview
Associates with a read-write view.
aclnum
Serial number of the ACL, which is associated with a specified
access list, specifies the IPV4 address range of the NMS that are
permitted to access the MIB.
aclname
Name of the ACL, which is associated with a specified access list,
specifies the IPV4 address range of the NMS that are permitted to
access the MIB.
ipv6_aclname
Name of the IPv6 ACL, which is associated with a specified access
list, specifies the IPv6 address range of the NMS that are permitted to
access the MIB
Defaults
No user group is set by default.
Command
mode
Global configuration mode
Usage Guide
None
Configuration
Examples
The following example sets a user group.
Ruijie(config)# snmp-server group mib2user v3 priv read mib2
Related
Commands
Command Description
show snmp group
Shows the SNMP user group configuration.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English