Command Reference Web Authentication Commands
Parameter
Description
Parameter Description
minutes
This parameter indicates the accounting update interval in minutes,
which ranges from 0 to 60 minutes. The default value is 0, indicating
no accounting update.
Defaults
0 minutes by default.
Command
mode
Global configuration mode
Usage Guide
If the Access-Accept message replied by the server carries the attribute of accounting
update interval and the attribute value is not 0, this value will be used as the accounting
update interval, or else the accounting update interval configured on the device will be
used.
This command can only be displayed and supported after the second-generation web
authentication has been enabled.
Configuration
Examples
#Configure the accounting update interval for Ruijie second-generation web authentication as 3
minutes.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# web-auth acct-update-interval 3
Related
Commands
Command Description
show web-auth portal parameters
Shows parameters of the second-generation
web authentication.
Platform
Description
This command is supported only on wireless products.
web-auth accounting jitter-off
The web authentication accounting jitter-off function is disabled by default. When this function is
enabled, the checking time will not be counted in the users’ on-line time if users drop due to signal
problems or traffic problems. Use the no form of this command to include the checking time in the
To Next Page
Loading...
Need help?
General
