Command Reference IP Address Commands
Type
The type of hardware address, which is ARPA for Ethernet addresses
Related
Commands
Command Description
N/A N/A
Platform
Description
This command is not supported on Layer 2 switches.
show ip interface
Use this command to show information about the IP status of an interface.
show ip interface [ interface-type interface-number | brief ]
Parameter
Description
Parameter Description
interface-type
Speciies the interface type.
interface-number
Specifies the interface number.
brief
Shows brief configuration information about the IP addresses of the
layer-3 interface, including the interface primary IP address,
secondary IP address, and interface status.
Defaults
N/A
Command
Mode
Privileged user mode
Usage Guide
When an interface is available, RGOS will create a direct route in the routing table. An available
interface means that the RGOS software can receive and send packets through this interface. If the
interface changes from available status to unavailable status, the RGOS software removes the direct
route from the routing table.
If the interface is unavailable (two-way communication is allowed), the line protocol status will be
shown as UP. If only the physical line is available, the interface status will be shown as UP.
The results shown may vary with the interface type, because some contents are interface-specific
options.
Configuration
Examples
The following example shows the output result of the show ip interface brirf command.
Ruijie#show ip interface brief
Interface IP-Address(Pri) IP-Address(Sec) Status Protocol
GigabitEthernet 0/10 2.2.2.2/24 3.3.3.3/24 down down
GigabitEthernet 0/11 no address no address down down
To Next Page
Loading...
Need help?
General
