Ruijie RG-WLAN Series

Command Reference WLAN QoS Commands
total-user-limit
Limit for the entire WLAN
down-streams
Total downstream traffic limit of the WLAN
up-streams
Total upstream traffic limit of the WLAN
average-data-rate
average-data-rate
Average rate limit, ranging from 1 to 819200 in 8Kbps
burst-data-rate
burst-data-rate
Burst rate limit, ranging from 1 to 819200 in 8Kbps
no
Restores the traffic limit to the default value.
Defaults
No traffic limit is set by default.
Command
mode
Configuration mode.
Usage Guide
N/A
Configuration
Examples
Example 1: Configure the average downstream rate of WLAN 1 to 800Kbps and burst rate to
1600Kbps.
Ruijie(config)# wlan-based 1 per-user-limit down-streams average-data-rate
800 burst-data-rate 1600
Related
Commands
Command Description
wlan-qos ap-based { per-user-limit |
total-user-limit } { down-streams | up-streams }
average-data-rate average-data-rate
burst-data-rate burst-data-rate
Configures the AP-based in-band and
out-of-band traffic rate limits.
netuser mac-address { inbound | outbound }
average-data-rate average-data-rate
burst-data-rate burst-data-rate
Configures the Client-based in-band and
out-of-band traffic rate limits.
Platform
Description
This command is supported on fat APs.
wmm edca-client
Use this command to configure the client EDCA. Use the no form of this command to restore the
parameters to the default values.
wmm edca-client { back-groud | best-effort | video | voice } { aifsn [ aifsn-value ] cwmin
[ cwmin-value ] cwmax [ cwmax-value ] txop [ txop-value ] [ noack ] | cac [ optional ] } radio
[ radio-id ]
no wmm edca-client { back-groud | best-effort | video | voice } radio [ radio-id ]