Ruijie RG-WLAN Series Rgos Command Reference

Command Reference IPv6 Commands
Parameter Description Parameter
Description
interface-type
interface-number
( Optional ) Show the routing advertisement of the specified interface.
Defaults
N/A
Command
Mode
Privileged EXEC mode.
Usage Guide
Use this command to show the neighbor routers and the routing advertisement. If no interface is
specified, all the routing advertisement of this device will be displayed.
Configuration
Examples
The following example shows the IPv6 router
Ruijie# show ipv6 routers
Router FE80::2D0:F8FF:FEC1:C6E1 on VLAN 2, last update 62 sec
Hops 64, Lifetime 1800 sec, ManagedFlag=0, OtherFlag=0, MTU=1500
Preference=MEDIUM
Reachable time 0 msec, Retransmit time 0 msec
Prefix 6001:3::/64 onlink autoconfig
Valid lifetime 2592000 sec, preferred lifetime 604800 sec
Prefix 6001:2::/64 onlink autoconfig
Valid lifetime 2592000 sec, preferred lifetime 604800 sec
Command Description Related
Commands
N/A N/A
Platform
Description
N/A
tunnel destination
Use this command to specify the destination address for the tunnel. Use the no form of this command
to remove the setting.
tunnel destination { ipv4-address | ipv6-address }
no tunnel destination
Parameter Description
ipv4-address
Destination address of the tunnel, namely the IPv4 address in the
other side of the tunnel.
Parameter
Description
ipv6-address
Destination address of the tunnel. With the tunnel mode ipv6
configured, the destination address of the tunnel shall be the
IPv6 address. If the tunnel mode gre ipv6 is configured, the

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English