Command Reference Web Authentication Commands
Command
mode
Global configuration mode.
Usage Guide
When the wireless network environment is good (good signal and minor interference), it is suggested
to enable the wireless link failure detection so that the device can instantly detect the link failure of
users.
When the wireless network environment is poor (excessive interference), the user's wireless terminal
may log out and log in frequently. In such a case, it is suggested to disable this function and enable
the traffic detection function to detect whether the user has logged out, thus enhancing the user's
surfing experience.
Configuration
Examples
#Disable link detection and enable traffic detection.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# no web-auth sta-leave detection
Ruijie(config)# web-auth offline-detect flow
Related
Commands
Command Description
web-auth offline-detect flow
Low-traffic and connection failure detection.
Platform
Description
This command is supported only on wireless products.
web-auth update-interval
Use this command to set the interval of updating the online user information. Use the no form of this
command to restore the interval of updating the online user’s information to the default value.
web-auth update-interval seconds
no web-auth update-interval
Parameter
Description
Parameter Description
seconds
The parameter indicates the update interval, which ranges from 30 to
3,600 seconds.
Defaults
180 seconds by default
Command
mode
Global configuration mode
Usage Guide
N/A
To Next Page
Loading...
